Audi A3 8P Rear Tail Light Support Element Bracket Left Right N/O/S 8P4945567

Audi A3 8P Rear Tail Light Support Element Bracket Left Right is an original component from the Brackets and Mounts group, designed for stable mounting of the tail light to the vehicle body. Thanks to its factory geometry, it ensures secure support, proper load distribution, and precise alignment of the light relative to the bodywork, which translates into safe and predictable operation of the rear lighting.

Specifications and technical data

• SKU: 8P4945567
• Mark: Audi
• Condition: Used
• OEM Part Number: 8P4945567
• Substitutable numbers: 8P4945567, 8P4 945 567
• Location on the vehicle: Rear, Right, Left
• Part type: Light Mounting Bracket
• Category: Light Mounts & Brackets

Purpose and vehicle placement

The bracket is designed specifically for the rear body section of the Audi A3 8P generation and acts as a load-bearing element for the tail light. The design is intended for installation on both the left and right sides, which facilitates part selection during post-accident repairs or when replacing worn-out mounts. Its placement in the rear area of the vehicle means the bracket is responsible for:

• maintaining a stable position of the light relative to the body panel,
• reducing vibrations and play while driving,
• maintaining the correct gap between the light and the bodywork.

Construction and technical function

As a component from the Brackets and Mounts group, the bracket serves as a structural connector between the light and the body structure. Properly shaped mounting points allow for the correct transfer of loads resulting from suspension movement, trunk lid closure, and daily use. Key technical features include:

• factory fit for the shape of the Audi A3 8P tail light,
• designed locations for screws or mounting clips (in accordance with the factory solution),
• geometry ensuring repeatable light alignment after every removal and reinstallation.

Benefits of using an original bracket

Using an original bracket in the Audi A3 8P helps reduce the risk of problems typical of aftermarket replacements with inaccurate geometry. A correctly selected component:

• facilitates installation without the need for body or light modifications,
• helps maintain the correct body line and uniform gaps,
• reduces the risk of light housing cracks caused by stress. As a result, rear body repair is more predictable, and the final result is closer to the factory standard. This is particularly important for vehicles where maintaining consistent body geometry and proper lighting operation is a priority.

Condition, application, and part selection

The offered bracket is a used part, which in practice means it has been removed from a vehicle and verified for further installation suitability. This is a solution often chosen for post-accident repairs when it is necessary to replace damaged light mounts and the priority is to maintain the vehicle's original construction. Before purchasing, it is worth comparing the shape and mounting points with the element currently installed in your car. If in doubt, it is also helpful to verify the manufacturer's markings in the technical specifications section, which includes data such as brand, placement on vehicle, or condition.

Support for Audi rear lighting upgrades

If you are planning a comprehensive repair or upgrade of the rear lighting area in your Audi and need other components from the same group, such as additional brackets, mounts, or light holders, check the available parts in the Audi Brackets and Mounts category. If you are also considering repairs in other vehicle systems and are wondering whether to choose refurbishment or the installation of original used components, the article describing the practical aspects of such a decision may be helpful – see the cost-effectiveness analysis of original used components versus refurbishment.